The comprehensive set for the construction of a 4-meter greenhouse 3 sheets of cellular polycarbonate in the kind of rolls of 2.1 m length and a diameter of 60-90 cm. The thickness of the material is 4 mm.

If you would like, you can increase the length of the construction to 6 yards or longer. To do this, it is enough to attach a two-meter extension. When choosing a drawing, then pay attention to the distance between the arches. This figure must be 65 cm, that’s the most appropriate duration for the specified depth of this material. The diameter of the doors based on the maker’s drawing is 90 cm.

Before building a polycarbonate greenhouse, it is necessary to pick a spot for the place. If that is done properly, you can provide yourself with a crop of fresh veggies for the whole year.

The place for the future greenhouse is marked immediately in the preparation of their garden plot. So as to melt the snow in the positioning of their greenhouse as soon as possible, the best point on the site is going to be a slight elevation. In addition, in this location won’t need to be concerned about significant humidity as soil and air inside the structure.

Assemble a polycarbonate greenhouse on a raised site – means to take care of the best temperatures indoors.

When it is not feasible to place a greenhouse on an elevated position, you will need to pour a layer of fine crushed stone about 20 cm and the exact same layer of fertile soil to create seedbeds.

Before building a greenhouse in your garden plot, you should also think about where and how this structure will be installed. First, you must choose a place for this. The greenhouse ought to be located in a metropolitan region no less than a couple meters away from houses, barns and other structures.

How to Put in a greenhouse according to the Surfaces of the Planet

Be sure to measure gidpostroy.ru the dirt surface – it’s best to remove the surface. This will also eliminate weed seeds. And for ease of work, remove the soil in a place that’s about a meter wider on both sides of the rectangle you want.

In addition, it is worth thinking about having a base. As producers state, now most greenhouses don’t need it, especially if they (greenhouses) are used only in the summer and spring time. However, seasoned anglers still recommend earning an elementary foundation from a bar. It is very simple – it’s sufficient to link with each other utilizing metal screws and corners four pieces of wood using a cross-section of 10 * 10 cm. The size of such a base should be equivalent to the base of the upcoming greenhouse.

Simple bar foundation

You can also earn a strip foundation of concrete. He is more dependable than a bar foundation, but requires greater fiscal and labor expenses. By the way, the greenhouse, that is utilised in winter, with no and don’t do with it at all.

Stages of the creation of a strip base: a schematic representation

Many producers counsel to install greenhouse structures without building a foundation. For this function, they equip the framework with specific T-shaped legs, so the structure was firmly fixed. But, as practice shows, it’s still vital to construct a base: therefore and the basis will be more firmly fixed and the components of the foundation in touch with the ground, will be saved much longer in its original state.

The major issue is to see to the material with specific agents to protect the wood from moisture. The substance is usually installed on concrete cubes that are dug into the ground. For a six-meter structure, they want 10 pieces: four on either side and one at the middle of the ends.

Before you perform the greenhouse itself, you need to pick the best spot for it. It must be an even site, so that the frame was found equally, without distortions. It needs to be sunny and not obscured by buildings or trees.