Gypsum tiles must be laid properly, as not only the aesthetic appearance of decorative facing, but also the service quality of

this substance will depend on the engineering of work. The product is also universal, and it may be attached to plaster, concrete,

brick or gypsum board sheets, and provided that the surface of the foundation is even and has no defects.

In the event the defects of the foundation are important, it ought to be thoroughly treated with primer, and then a cement mortar

is made, which matches all of the cracks. Then the surface ought to be repeatedly primed and dried. Primer treatment is essential

to improve the bond between the tile and the wall. In this case, its makeup should decide on a particular, comprising elements

which block the appearance of fungus and mould.

In today’s interior of these rooms most often used gypsum tiles, even imitating natural brick or stone. To carry out decorative

finishing your self, it is essential first of all to pick a strategy of tile placement and prepare a remedy. It’s crucial to look

closely at the opposite side of the substance. When its surface has an embossed surface, then the glue ought to be placed using an

even trowel, and if it’s even, then using a notched one.

The technology of the work is as follows:

* A thin coating of glue is placed on the pre-prepared wall. It is distributed over the base so that it is possible to place 4-5

tiles. Decorative cladding may be placed either on plasterboard, also on putty.

* Cover the back side of these tiles with adhesive.

* Plaster elements are pressed against the wall and their place is adjusted. To align with the seams, it’s advised to use

spacers.

* Finishing is carried out in rows, all which ought to be shifted by half a tile. Facing is completed into the corners of this

room, then immediately eliminate any remaining mortar at the joints.

Drying the walls requires no longer than a day and requires a constant humidity and temperature within the room. The final stage

in the laying of gypsum tiles is their own decoration. To get this done, the joints between the elements are filled with a

particular solution, the shade of which suits the brick.

Cosmetic fake of brickwork around the walls will be carried out in the following ways:

* Cutting the darkened surface of the stitches of masonry with a bolt cutter with your hands;

* placing of tiles beneath the brick:

* mimicking the structure and colour of the side of one brick;

* Imitating a fragment of brickwork of many bricks.

The very best method to decorate »under the brick » will be the one that permits you to make a practical coating with the most

appearance of its resemblance to organic masonry. All 3 approaches to conduct this kind of finishing works meet the demands, but

the cutting edge of joints with a bolt is labor-intensive and the formation of considerable amounts of dust, and so let’s consider

more typical ways.

The old finish is removed from the walls, and the surface, if necessary, is leveled to eliminate the need to paste plaster onto a

thick coating of adhesive.

Combining these cladding with different types of interior finishes could be both orderly and done with no apparent consistency,

chaotically, together with imitation of indications of aging.

With the support of cosmetic gypsum tiles it’s possible to imitate a large number of textures.

A lot of textures can be imitated with the help of decorative gypsum tiles.

The wall where it’s to be set up should possess the following attributes:

* Hardness and strength of the surface;

* The absence of uneven areas and sharp sections;

* no more deformations.

Decorative tiles in the interior of this kitchen

Walls are made from a number of substances, so let’s break down the individual rules of installation.

When dealing with concrete, there will be no huge problems. It is only necessary to take into consideration the porosity of the

material. Concrete, which has almost no pronounced pores, should be treated with a great primer.

Mounting gypsum tiles on concrete

Before beginning work on the setup of gypsum tiles on the walls, it is worth assessing the strength of this surface. When the

plaster doesn’t drop off the masterfasada.ru wall and at the identical time holds well, you can simply paint it using primer.

Mount the tiles on the painted concrete should not. The surface should be scratched, making sure to misfire, then it ought to be

grouted and covered with a coating of plaster.